Raspberry Pi 5 as network storage, music server, and player - PART 7

7. READY TO GO

We are now fully set up and ready to play music, to a separate streamer/endpoint.

This is my rPi5 piCorePlayer-Lyrion server streaming to a WiiM Mini, with optical S/PDIF output to a Topping E30 II lite DAC.
As you can see, I can play 192 kHz PCM files to the DAC, which is the highest sample rate the WiiM can handle, and also the highest rate optical S/PDIF can handle.

Comments

Post a Comment

Popular posts from this blog

Raspberry Pi 5 as network storage, music server, and player

1. OVERALL SYSTEM CHOICE Music servers and network audio are subjects which appear regularly on hifi forums, often regarding the overall system configuration - whether to host a music server on a personal computer, or a standalone server, or network attached storage device.  Quite a few of us have chosen the latter option; NAS, but this can be difficult for a newcomer - commercial NAS devices often bundle their own branded server software, which then can make it confusing to know which control apps are compatible, and if other devices such as streamers can be integrated. A good alternative to commercial NAS devices is a suitably configured Raspberry Pi mini-computer, but again, newcomers are often nervous about how complicated this may be to assemble and configure.  And to make the idea even less appealing there are some howto's on the internet which show a messy collection of electronic boards connected by an equally messy series of cables! With the introduction of the Raspbe...
Read more

Raspberry Pi 5 as network storage, music server, and player - PART 2

Image
  2. CHOICE OF HARDWARE There are many choices of equipment case for a Raspberry Pi 5 plus NVME drive.  These are my two favourites - The smaller one - Pimoroni - accommodates a conventional Raspberry Pi 5 plus M.2 drive, while the larger case - Geekworm - accommodates a Raspberry Pi Compute Module 5 plus 2x M.2 drives.  The Geekworm case is 96 x 90 x 44mm - that's still smaller than an Intel NUC.  The Pimoroni case is a tiny 95 x 60 x 37mm. I chose the larger Geekworm case, since I was aiming to add an OLED display at a later stage, and the small case is simply too small to accommodate a display of any sensible size. The larger case is designed for the Raspberry Pi Compute Module 5, not the "normal" Raspberry Pi 5.  The difference is that the Compute Module consists only of the CPU, RAM and network modules. It's then plugged into a matching carrier board to provide physical connectivity - USB/ethernet/M.2/GPIO, etc. Geekworm sells a matching passive heatsink ...
Read more

Raspberry Pi 5 as network storage, music server, and player - PART 3

 3. CHOICE OF SOFTWARE First we will deal with the situation where our rPi is both network storage and music server, but we want to stream to a separate endpoint/streamer ; Many/most commercially available streamers only support the DLNA/UPnP protocol.  If you have such a streamer, and you wish your rPi to be a DLNA server, then I think the most straightforward choice of operating system for the rPi is DietPi , which makes it easy to install and run a DLNA server ... however ... I encourage everyone to consider the Lyrion music server instead.  Lyrion opens the door to, arguably, the very best selection of control interface applications.  And the best operating system for the rPi with Lyrion, arguably, is piCorePlayer (pCP) - https://www.picoreplayer.org/ As a bonus, pCP includes an intuitive setup menu, making it relatively easy to configure the music server settings, and optionally the player settings, and also the network file sharing settings. To follow is a f...
Read more